next time your Stralis throws a regeneration warning. With the free knowledge above, you are already miles ahead of a blind tow to the dealership.
If you have a code not listed above, use the to understand the nature of the electrical problem: 02 : Data erratic or incorrect signal . 04 : Voltage below normal or shorted to low source .
The RFC receives data from the height sensor that defies physical logic (e.g., voltage too high or too low). This indicates a snapped sensor linkage arm or a failed internal potentiometer in the sensor.
Searching for yields low-quality results. You might find a PDF list of blink codes from 2005, but it will likely be useless for a modern Stralis.
The Rear Frame Computer (RFC) is located on the right side of the frame, just before the crossbeam. It acts as a bridge between the front controls and the rear components. When this unit detects a problem—like a blown bulb, a broken wire, or a faulty sensor—it sends a signal to the dashboard. Common RFC Fault Codes & Meanings
The following codes are often associated with the Rear Frame Controller (RFC) module in the Iveco Stralis, usually displayed as a or similar warning on the dashboard: