Ydrp2040 Schematic __hot__ Jun 2026

The YD-RP2040 hardware development board Go to product viewer dialog for this item.

The schematic indicates a flexible power input. The board can be powered via the USB-C connector or directly through the VBUS/VSYS pins. ydrp2040 schematic

: Altium/KiCad compatible files, including the base board layout, are hosted on vcc-gnd GitHub Technical Discussions The YD-RP2040 hardware development board Go to product

The YD-RP2040 adds a — a welcome improvement over the original Pico. In the schematic, this button connects to the RUN pin of the RP2040. When pressed, it pulls RUN low, resetting the chip. A pull‑up resistor (typically 10 kΩ) keeps RUN normally high, preventing spurious resets. : Altium/KiCad compatible files, including the base board

The RESET button pulls the RUN pin to ground, and the BOOTSEL button pulls GPIO 20 (or similar, check specific rev) to ground during boot. 3. YD-RP2040 Pinout Diagram

Connected to a button that pulls the BOOTSEL pin low during power-up to enter USB Mass Storage Mode. 4. USB-C and Peripherals