T.vst59.031 Firmware 1366x768 //free\\

Check your panel data sheet for its operating voltage. Set the jumper on the T.VST59.031 board to 3.3V, 5V, or 12V BEFORE powering it up. Applying 12V to a 3.3V panel will permanently destroy the display logic board.

Enter the Factory Service Menu by pressing Menu + 1147 (or Source + 2580 ) on the remote control. Look for a setting labeled LVDS Map , Panel Config , or TI Mode , and toggle the value (0 to 1, or VESA to JEIDA) until the colors render normally. 2. The Screen Image is Upside Down T.vst59.031 Firmware 1366x768

The image is stretched, compressed, or completely out of sync. Check your panel data sheet for its operating voltage

This is the most reliable method for 90% of boards. or TI Mode