Request a Quote

Fanuc 11m Parameter List

Our electrical motors, customized structurally and electrically, are designed following the EU directives ECODESIGN and International norms of reference. Constructively motors are available in a version with feet (B3) and equipped with flange, inside which is an elastic coupling. Thermal protection, properly studied, guarantee performance in any type of service and against misuse or accidental cases.

Fanuc 11m Parameter List

All critical data (parameters, programs, offsets) on a Fanuc 11M is stored in volatile SRAM memory that requires constant power from a backup battery when the main power is off. Losing battery power means losing everything. Replacing this battery is a straightforward but critical maintenance task.

: Sets program storage capacity (e.g., 100 or 200 programs). 9111 Bit #0 : Macro B option. 9116 Bit #0 : Enables the Part Counter feature. fanuc 11m parameter list

| Feature | Description | |--------|-------------| | | Unlike later Fanucs (0i/16i use 5-digit), 11M is strictly 0000–9999. | | Bit/Byte split | Some parameters are bit (0/1), some are byte (0–255), some are 2-byte (0–65535). The manual indicates format as B (bit), BY (byte), or 2BY (2-byte). | | No Parameter Write Enable (PWE) | On 11M, to edit parameters you must set PWE = 1 (parameter 0000 bit 0) and cycle power, or use MDI mode + parameter write enable switch (if wired by MTB). | | Separate CNC vs. Servo Parameters | The 11M splits them: 0000–0999 (CNC general), 1000–1999 (axis config), but servo tuning is in 0100–0899. | | Option parameter unlocking | Many option bits (e.g., 4th axis, helical, scaling) are protected; changing them requires a special password (often series-specific, not user-changeable without Fanuc hardware key). | All critical data (parameters, programs, offsets) on a

Setting axis pulses-per-mm:

| Parameter | Description | | :--------- | :------------------------------ | | | Number of axes | | P0001 | Spindle settings (e.g., number of spindles, spindle type) | | P0002 | Feed rate settings (e.g., rapid traverse rate, cutting feed rate) | : Sets program storage capacity (e